LogViewer
|
|
---|---|
Hello All I was exploring logviewer. I have set LoggingLevel=DEBUG Loggingtarget=file CurrentLoggingTarget=file::/path/family_class_member.log For every device, I have done this. It makes different file for every device. I have to log parameters related to every device in one file. How can I have one file for every device in which parameters related to every device is logged ? Thanks and Regards TCS-GMRT TEAM
Regards,
TCS_GMRT |
|
|
---|---|
Hello, I have just done a quick test and I do not have problem to get several devices log messages within the same file. For each device, when the DS is running, in Jive open "Logging" and set: 1 - Current logging level to DEBUG (for instance) 2 - Current logging target to "file::/tmp/<a file>" (for instance) After a while, you may stop the DS and load the logging file (/tmp/<a file>) in LogViewer Regards Emmanuel |
|
|
---|---|
Hello Manu I tried the above steps but I am unable to set the same file name for each device. Its throwing exception. Any Suggestions ? Thanks and Regards TCS-GMRT TEAM
Regards,
TCS_GMRT |
|
|
---|---|
Hello, Take care of the syntax you use when you specify the file name. It is "file::/<a file name>" Note the file::/ Is it what you have used? Regards Emmanuel |
|
|
---|---|
Hello, - is there a specific syntax for windows file? Is is / or \, like file::F:\my\log\file.log - in jive, where should I put this log file? In "current logging target" or in "Logging target"? - What is the separator if I put several targets? Thanks, regards, Laurence. |